仓库地面应能够承受剧烈的地面负载条件。带有小直径轮子的叉车和运输设备容易受到较小的地板高度偏差的影响，从而导致它们在行进时摇摆。载重行驶时，车辆的摇晃会随着桅杆的延伸而出现问题。还应考虑地面负荷-机架竖立脚印需要增加额定负荷。如果未经过设计以满足这些要求，则在同一路径上重复执行车辆操作可能会导致地板开裂。
线引导操作-密切注意平板接头。避免沿平板边缘（伸缩缝）放置导线路径。伸缩缝应隐藏在机架轮廓下方。不可避免时，伸缩缝应以垂直方式穿过路径。
The Warehouse Floor shall be capable of withstanding strenuous floor load conditions. Forklifts and transport equipment with small diameter wheels are susceptible to minor floor height deviations causing them to sway as they travel. Vehicle sway becomes problematic with mast extension while traveling with loads. Also consideration should be given to floor loading - rack upright foot prints require increased load ratings. Repeated vehicle operation on the same path may cause floors to crack if not engineered to meet these requirements.
Wire guided operation - pay close attention to slab joints. Avoid placing wire guide paths along the edge of a slab (expansion joint). Expansion joints should be hidden under the rack outline. When unavoidable the expansion joint should cross the path in a perpendicular fashion.